Table of Contents
Advertisement
•
The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
•
Always put the cutting deck in servicing position
to clean it. Do not park the product near the edge
of a ditch or slope to get access to the cutting
deck.
CAUTION:
instructions that follow before you use
the product.
Introduction
WARNING:
the safety chapter before you assemble
the product.
To remove the product from the
carton
1. Remove loose parts included with the product.
2. Remove the end panels.
3. Remove the side panels and put them on a flat
surface.
4. Remove all package materials.
5. Remove the product from the carton and make
sure no loose parts are left in the carton.
Assembly tools
•
1/2" (13 mm) wrench
•
7/16" (11 mm) wrenches (2 pieces)
•
Tire pressure gauge
•
Knife
•
Pliers
•
Socket wrench set (optional)
Loose parts that need assembly
The product is not fully assembled. The parts that
follow are loose when the product is purchased.
Key, 2 pcs
Slope sheet, 1 pcs
Oil drain tube, 1 pcs
10
Read the caution
Assembly
Read and understand
•
Do not turn over the engine if the spark plug or
ignition cable is removed.
•
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good
condition.
•
Do not change the adjustment of governors.
If the engine speed is too high, the product
components can become damaged.
•
The product is approved only with the equipment
supplied or recommended by the manufacturer.
Hose connector, 1 pcs
Hex bolt, 2 pcs
Nuts, 2 pcs
To adjust the seat
1. Lift the seat up and remove the seat adjustment
knob (A).
2. Loosen the seat adjustment knob (B).
A
3. Move the seat until it is in a position where you
can push the brake and clutch pedals down.
4. Line up the hole in the seat plate for seat
adjustment knob (A) with the hole in the seat.
5. Install and tighten the seat adjustment knob (A).
6. Tighten the seat adjustment knob (B).
B
2285 - 001 - 17.10.2023
Advertisement
Table of Contents
