Husqvarna P 535HX Operator's Manual page 42

Quick maintenance guide - R180 cutting deck
Symbols on the quick maintenance
guide
Replace the filter
Replace the oil
Examine visually or do a check of the oil
level
Lubricate the grease nipple with grease
Lubricate with engine oil
Do a check of the condition and tension of
the drive belt
Replace the drive belt
42
Replace the blades
Lubrication, general information
• Remove the power key to prevent accidental
movements during lubrication.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION: Do not use gasoline or other
petroleum products to clean drive belts.
To clean the product
WARNING: Turn the power key to the STOP
position and turn the main switch to OFF
before you clean the product.
1262 - 004 - 04.06.2020