Husqvarna P 535HX Operator's Manual page 29

7. Start the electrical drive. Refer to
product on page 33 .
8. Put the lever for the hydraulic lifting arms to the
position (B) to lower the lift arms.
C
B
A
WARNING: Do not put the lever for the
hydraulic lifting arms to the float position
(A). The hydraulic force can cause injury.
9. Turn the power key to the STOP position.
10. Remove the 2 screws and remove the bottom plate.
11. Pull back the rubber casing from the shaft joint.
12. Pull back the couplings of the drive shaft and remove
the drive shaft from the PTO shaft on the product.
13. Pull back the couplings of the drive shaft and remove
the drive shaft from the bevel gear shaft of the
cutting deck.
14. Remove the locking chains.
15. Remove the pins (A) and the bolts (B) from the lifting
arms (C) and joints of the cutting deck (D).
1262 - 004 - 04.06.2020
To start the
D
a) For the Combi cutting decks:
B
A
D
b) For the R180 cutting deck:
B
A
To put the Roll Over Protection
Structure (ROPS) in position for the
first time
For the transportation of the product from the factory,
the ROPS is folded above the seat.
1. Remove the screws that attaches the ROPS to the
product.
180°
2. Turn the ROPS 180 degrees.
3. Install the ROPS with the screws.
B
A
C
B
A
C
29