Husqvarna P 535HX Operator's Manual page 53

2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck.
a) Combi 155 must be measured in 2 areas. Make
sure that the rear edge is 6–9 mm (1/4 - 3/8 in.)
higher than the front edge.
b) Combi 155 X must be measured in 4 areas.
Make sure that the rear edge is 6–9 mm (1/4 -
3/8 in.) higher than the front edge.
To adjust the parallelism of the cutting deck
1. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the cover.
Make the track rod shorter to lower the rear edge of
the cover.
2. Tighten the nuts on the track rod.
1262 - 004 - 04.06.2020
3. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
52 .
4. Attach the front cover.
To replace the belt on the cutting deck
1. Remove the 3 screws that holds the belt cover.
2. Remove the belt cover.
3. Attach the service stay to the tension spring.
4. Push the service stay and remove the belt.
5. Attach the belt around the pulleys as shown in the
illustration.
Cutting deck - R180
To examine the blades
WARNING: Damaged or incorrectly
balanced blades can cause damage
to the product. Replace damaged
blades. Let an approved service
agent help you sharpen and balance
blunt blades.
1. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
2. Tighten the blade bolts with tightening torque 125
Nm (12.75 kpm / 92 lbft).
To do a
53