Husqvarna P 535HX Operator's Manual page 34

CAUTION: Do not use the product if the
temperature in the 48 V batteries are
less than 0 °C/32 °F.
WARNING: When the hydraulic motor
stops, the product is in operation and
without noise. If the manual parking
brake is not engaged, the product moves
if you push the forward or rearward
pedal.
Note: If you get a fault indication when the product is
in electrical drive, you must push the start button for
the electrical drive again. For example if you lift from
the seat and the manual parking brake is not
engaged.
4. Push the start button for the hybrid drive (B) to start
the engine.
Note: You can also start the hybrid drive directly,
without the electrical drive is on, if the product is
stationary.
To stop the product
1. Park the product on level ground.
2. Apply the manual parking brake.
3. If the cutting deck is engaged, push the PTO button
to disengage the drive on the cutting deck.
4. Push the lever for the hydraulic lifting arms forward
to lower the cutting deck to the ground.
34
5. Turn the power key to the STOP position. The
hydraulic system pressure releases.
Note: To stop the hybrid drive only, push the start
button for the electrical drive.
6. At the end of operation or when you do maintenance
on the product, turn the main switch to OFF.
To operate the product
1. Start the product. Refer to
page 33 .
2. Release the parking brake.
To start the product on
1262 - 004 - 04.06.2020