Dataman 448PRO2AP User Manual page 99

PG4UW
Job Report is generated in following cases:
 user command Load project is selected
 closing or disconnecting programmer sites is selected
 closing the PG4UW
 device Count down counter reaches 0 (finished status)
 manually by user, when menu "File / Job Report" is used
The Job Report is generated for recently loaded project file, only when statistics value of Total
is greater than 0.
It means, at least one device operation (program, verify...) must be performed.
Following options are available for Job Report:
Checkbox Enable Job Report function - when checked, the Job Report function is active
(enabled). Otherwise the Job Report function is disabled.
Checkbox Automatically save Job Report file - when checked, the Job Report will be saved
automatically to directory specified in edit field Job Report directory and with file name created
as following:
job_report_<ordnum>_<prjname>.jrp
where
<ordnum> is decimal order of the file. If there are any report files with the same name, then
order for new report file is incremented about order of existing files.
<prjname> is project file name of recently used project, and without the project file name
extension.
Example 1:
Let's use the project file c:\myproject.eprj and directory for Job Report set to d:\job_reports\.
There are no report files present in the Job Report directory.
The final Job Report file name will be:
d:\job_reports\job_report_000_myproject.jrp
Example 2:
Let's use the conditions from Example 1, but assume there is already one report file present.
Name of this file is d:\job_reports\job_report_000_myproject.jrp
The final Job Report file name of new report will be:
d:\job_reports\job_report_001_myproject.jrp
Note: The order inside file name is incremented by 1.
When Automatically save Job Report file setting is set, no Job Report dialogs appears when
generating Job Report. Newly generated Job Report is saved to file without any dialogs or
messages (if no error occurs while saving to file).
If the checkbox Automatically save Job Report file is unchecked, the PG4UW will show Job
Report dialog every time needed.
99