Dataman 448PRO2AP User Manual page 128

Eject plate from shaft (<Delete>)
Ejects pressure plate from shafts. Command also invalidates preset configuration of ZIF socket
actuation unit.
Place the pressure plate to shafts and automatically configure the ZIF socket actuation
unit (Insert)
Attaches pressure plate to shafts of servo motors. The position of attached plate will be set as
base position. It is a reference position and all pressure plate movements are related to this
position. At ending the work the PG4UWMC software moves pressure plates of all ZIF socket
actuation units to base position. The pressure plate configuration is read
from values stored in INI file or are used default
values based on detected programming module.
Move pressure plate to base position (<Home>)
Moves pressure plate to preset base position.
Set current position of pressure plate as base position (<Ctrl+Home>)
Sets current position of pressure plate as base position.
Pressure plate up (<Up>)
Moves pressure plate upwards. Use this for adjust pressure plate position towards up (closing
ZIF socket). Pressure plate is moved by both servos at a time. For increasing movement
speed press and hold the <Shift> key.
Upper up (<LeftCtrl+Up>)
Adjusts pressure plate position towards up by upper servo only. Use this command to level out
pressure plate.
Lower up (<RightCtrl+Up>)
Adjusts pressure plate position towards up by lower servo only. Use this command to level out
pressure plate.
Pressure plate down (<Down>)
Moves pressure plate downwards. Use this for adjust pressure plate position towards down
(opening ZIF socket). Pressure plate is moved by both servos at a time. For increasing
movement speed press and hold the <Shift> key.
Upper down (<LeftCtrl+Down>)
Adjusts pressure plate position towards down by upper servo only. Use this command to level
out pressure plate.
Lower down (<RightCtrl+Down>)
128