Dataman 448PRO2AP User Manual page 119

PG4UWMC
Use settings according to the last loaded project file - Automatic YES! option is set by the
settings in project file. One of the setting's items of Automatic YES! is 'Pins of programmer's
ZIF excluded from sensing', which is depend on used programming adapter. Because it is
possible that different programmers use different programming adapters for same device, this
setting will be ignored in this case and in the log window you can find following sentence:
"None connected pins setting was not accepted due to different programming adapter. Please
use automatic YES wizard again." If this case occur go on master programming site (if you run
PG4UWMC with option 'Use Site #1 project for all Sites') or on programming site which wrote
previous mentioned sentence to log and click on the button 'Setting Automatic YES!
parameters' in Programmer / Automatic YES! options.
Settings of 'Indication of state when software waits for a new device' and 'Enable sound when
ready for a new device' is not stored in project file.
Enabled - Automatic YES! function is enabled on all connected programming site with
parameters set by PG4UWMC.
Disabled - Automatic YES! function is disabled on all connected programming site. Use this
setting if you need to use button YES! for starting a next operation with the programmed
device.
Response time - interval between insertion of the chip into the ZIF socket and the start of
selected device operation. If longer positioning of the chip in the ZIF socket is necessary select
elongated response time.
Device removal hold off time - time period between you removed device from the ZIF socket
and the time when software starts to check the socket for new device inserted. This time is in
seconds and must be from 1 to 120 (default value is 2 seconds).
Device insertion complete time - time within all pins of the device have to be properly
inserted after a first pin(s) detected so that the program will not detects incorrectly inserted
device. This interval is in seconds and must be from 1 to 120 (default value is 5 seconds).
Suspend on error - defines if the Automatic YES! function will be temporary disabled on error
to see result of operation or will going on without suspension.
Indication of state when software waits for a new device:
Not indicated (quiet mode) - the programmer, regardless of the number of ZIF sockets of the
programmer, does not indicate the state when a device is programmed and the programmer
with software wait for inserting a new device. After an operation with a device only one of the
status LEDs Error or OK lights, in dependence on the result of previous operation. This LED
goes off immediately after detecting removal of a device from the ZIF socket.
By LED Busy blinking - the programmer, regardless of the number of ZIF sockets of the
programmer, indicates the state when a device is programmed and the programmer with
software wait for inserting a new device mode by blinking with the LED Busy. After an
operation with a device is done, one of the status LEDs (OK or Error) lights, in dependence on
the result of previous operation and the LED Busy is blinking. If the program detects removal of
a device from ZIF socket, then the status LED goes off, but the LED Busy is still blinking to
indicate readiness of the program to repeat last operation with new device. After the program
119