Dataman 448PRO2AP User Manual page 105

of these operations (especially Program and Erase) may contain embedded sub-operations,
editable via Menu/Device/Device options.
 Multi-project Wizard - an assistant for Multi-project file building. The Wizard allows user to
select projects that have to be included in Multi-project and save them to one Multi-project
file. Process of saving selected project files to one Multi-project file is called Multi-project file
building. The Wizard also allows to start device operation according to projects (sub-devices)
included in Multi-project. More information about Multi-project Wizard is described bellow.
Multi-project Wizard
Multi-project device operation requires Multi-project file, which contains partial sub-projects
associated to sub-devices (chips) of Master device. Multi-project file can be created in Multi-
project Wizard. The Wizard has following main functions:
 Select of sub-projects and build final Multi-project file
 Load of existing Multi-project file
 Start device operation of recent Multi-project
Note: Existing Multi-project file can be loaded from main menu of PG4UW using menu File /
Load project or from Multi-project Wizard by Load multi-prj command.
Multi-project Wizard contains following controls:
 Button Load multi-prj is used for load of existing Multi-project file.
 Button Build Multi-project is used for build of new Multi-project file, which uses projects
listed in table Sub-projects.
 Table 1: Sub-projects contains list of projects that are included in recent Multi-project.
 Button Add project is used for adding of new project file(s) to list of project files in Table1.
 Button Remove project is used for removing of selected project file from list of project files
in Table 1.
 Buttons Move up a Move down are used for moving of selected project in Table 1 one
position up or down. Projects are processed in specified sequence order, the upper-most
(#1) as first.
 Button Help show this help.
 Buttons of device operation Blank, Verify, Program, Erase, or Run are used for running of
selected device operation on all chips (sub-devices) listed in table Sub-projects.
 In "Multi operation" mode, one of all available operations can be run at a time (the same
operation on each sub-device).
 In "One operation" mode, only one operation can be run (the same operation on each
sub-device) or each subproject can run it's own (one) operation, depending on projects the
Multi-project consists of.
Following two basic actions have to be performed when using Multi-project to program
Multi-chip devices (similar also for Single-chip devices):
 Making (building) of Multi-project (or Multi-project file)
 Using of Multi-project for running of device operation
Making (building) of Multi-project (or Multi-project file)
Following steps are recommended when making Multi-project file:
 Create "classic" projects, one project for each sub-device of multichip device. Projects are
created in the same way as projects for generic devices:
 select sub-device according to required chip of multichip device *1
105
PG4UW