Programmer - Dataman 448PRO2AP User Manual

The reserved key <Ctrl+F1> will bring out this menu from any menu and any time immediately.

Programmer

Menu Programmer includes commands used for work with programmers.
Programmer / Find programmer
This item selects a new type of programmer and communication parameters. This command
contains following items:
Programmer - sets a new type of programmer for find. If a Search all is selected, the control
program finds all supported programmers.
Establish communication - allows manual or automatic establishing communication for a
new programmer.
Speed - sets speed, if a manual establishing communication is selected, which PC sends data
into the programmer. Speed is expressed as a percent from a maximal speed.
Port - selects a port, which will be scanned for a requested programmer. If All port is selected,
the control program scans all ports, which are available on standard addresses.
Pressing key <Enter> or button OK initiates scanning for programmer by set parameters.
There is same activity as at start the control program. The command clears a list of default
devices without the current device, if the new selected programmer supports this one.
This setting is saved to disk by command Options / Save options.
Programmer / Refind programmer
This menu command is used to refind (reestablish communication with) currently selected
programmer.
To select other type of programmer, programmer communication parameters and to establish
communication with newly selected programmer use menu Programmer / Find programmer.
91
PG4UW