Dataman 448PRO2AP User Manual page 126

From this point, working with PG4UWMC should be as usual.
Troubleshooting
If searching programmers does not finish as expected, please check following:
 each computer in Programmers group must run PG4UWMC Network Agent with same
Programmers group
 your firewall settings may block network communication, please check firewall rules or
temporally disable firewall.
ZIF socket actuation unit
The functions for controlling the ZIF socket actuation unit(s) are enabled only if the
PG4UWMC detects the programmer(s)
Communication between PG4UWMC software and ZIF socket actuation control unit(s) is
interfaced by application ClientZifAct. This application is started automatically after accepting
found programmers. Its presence/running is indicated by icon displayed in system tray:
The ZIF socket actuation units are automatically controlled by the PG4UWMC switched in
remote control mode. At starting remote control mode, the PG4UWMC firstly check the
programming modules and after this starts recalibration of ZIF socket actuation unit for each
enabled site.
Note: Before starting remote control mode be sure that ZIF socket actuation units are
configured for used programming modules!
ZIF socket actuation unit configuration
Start the ZIF socket actuation unit configuration by running command Configure ZIF socket
actuation unit from main menu or respective site pop-up menu, see figures below.
Search in Programmers group on network
126
with the ZIF socket actuation units.