Dataman 448PRO2AP User Manual page 106

 set device parameters, settings, and load required device data to buffer by Load file
command in PG4UW
 optionally make test of device operation by running the device operation on device
 if everything is OK, the project file can be created by Save project command
 Select Master multichip device, the Multi-project has to be used for. After selection of
multichip device, Multi-project Wizard is automatically opened.
 In Multi-project Wizard add required projects by Add project button. Each project represents
one sub-device of multichip device.
 After completing of sub-project selection, use button Build Multi-project to create final Multi-
project file. Program will prompt for name of new Multi-project file. Final Multi-project file will
contain all sub-projects listed in Table 1: Sub-projects.
Note: There is possible to create Multi-project from any classic project files. So association
with Master device is not mandatory. It is only on user's consideration how to combine correct
sub-devices (sub-projects) into one Multi-project. This feature can be especially useful when
using ISP programming of devices in JTAG chain with different projects defined.
Multi-project Wizard can be opened by one of following actions:
 selecting of Master multichip device from Select Device dialog in PG4UW
 loading of created Multi-project file
 opening dialog Multi-project Wizard directly from PG4UW menu Options / Multi-project
Wizard
*1 Convention for Master-device and Sub-device part names in PG4UW device list:
Master-device:
Sub-devices:
Example:
Master-device:
Sub-devices
Using of Multi-project for running of device operation
Typical usage of existing Multi-project file has following order.
For single programming in PG4UW:
 Load created Multi-project by File / Load project menu command in PG4UW main window
or Load multi-prj button in Multi-project Wizard. After successful loading of Multi-project,
Multi-project Wizard is opened automatically.
 In Wizard run wished device operation using one of available device operation buttons
(Blank, Verify, Program, Erase), mostly Program device operation is used. Selected device
operation is executed as sequence of sub-project loading and consequent sub-device
programming for each sub-device defined in Multi-project. And this is main purpose of Multi-
project - to automate running sequence of device operations for each chip of multichip
device. The side effect of this concept is that device progress indicators are reset to 0 at
beginning of each sub-device operation, so it looks like progress bar is "jumping" to 0 few
times while multichip operation is running.
Multichip_original_part_name [package_type]
Multichip_original_part_name [package_type] (part1)
Multichip_original_part_name [package_type] (part2)
...
Multichip_original_part_name [package_type] (part n)
TV0057A002CAGD [FBGA107]
#1 TV0057A002CAGD [FBGA107] (NAND)
#2 TV0057A002CAGD [FBGA107] (NOR)
106