Studio Monitoring - Yamaha 02R96 Owner's Manual

Control Room Setup
Control room monitoring is configured on the Control Room Setup page.
1 Use the MONITOR [DISPLAY] button to locate the Control Room Setup page.
Use the cursor buttons to select the ASSIGN buttons in the left-hand box,
2
and use the Parameter wheel to select an Output Channel in the right-hand
box.
Bus Outs or Aux Sends can be assigned to the [ASSIGN 1] and [ASSIGN 2] buttons.
3 Press [ENTER] to assign the selected Output Channel.
Once assigned, the selected Output Channel appears highlighted in the right-hand box.
The other parameters on this page are as follows.
CONTROL ROOM DIMMER LEVEL: This determines the amount of attenuation
applied to the Control Room Monitor and Surround Monitor signals by the Dimmer func-
tion. Use the cursor buttons to select it, and use the Parameter wheel or INC/DEC buttons
to set it from.
MONO: This button is be used to switch the Control Room Monitor signal into mono.

Studio Monitoring

The STUDIO MONITOR OUT uses balanced 1/4-inch phone jacks,
nominal level +4 dB. Typically it's used to feed monitoring systems in the
actual studio.
STUDIO
CONTROL STEREO
ROOM
AUX7 AUX8
The level of the Studio Monitor signal can be set by using the STUDIO LEVEL
control.
0 10
STUDIO
LEVEL
The Studio Monitor signal source is selected by using the STUDIO but-
tons.
[CONTROL ROOM]: Selects the Control Room Monitor.
[STEREO]: Selects the Stereo Out.
[AUX 7]: Selects Aux Send #7.
[AUX 8]: Selects Aux Send #8.
115
Studio Monitoring
02R96—Owner's Manual