10 Aux Sends
Patching Aux Send Masters to Outputs
Aux Send Masters can be patched to the Slot Outputs, Omni Outs, or the 2TR Digital Out-
puts. See "Output Patching" on page 54 for more information.
Setting the Aux Send Mode
Aux Sends have two operating modes—Variable and Fixed—which can be set individually
for each of the eight Aux Sends. In Variable mode, Aux Send levels are variable and the signal
source point can be either pre-fader or post-fader. In Fixed mode, Aux Send levels are fixed
at nominal and the signal source point is fixed to post-fader.
Use the AUX SELECT [DISPLAY] button to select the Aux Send pages.
1
The Aux Send parameters for the 56 Input Channels are divided among three pages. The
Input Channel 1–24 Aux Send page is shown below: Variable mode on the left, Fixed mode
on the right. The layout of the other two pages is the same.
On the Fixed mode page, "GLOBAL POST" is displayed in the lower-right corner, indicat-
ing that the Aux Send Pre/Post parameter is fixed at Post.
2
Use the AUX SELECT [1–8] buttons to select Aux Sends 1–8.
Use the cursor buttons to select the FIXED and VARIABLE buttons, and press
3
[ENTER] to select a mode.
When the Aux mode is changed, the parameters of the selected Aux Send are set as follows.
Parameters
Level
Pre/Post
On/Off
Pre-Fader or Post-Fader Aux Sends
Aux Sends can be configured individually as either pre-fader or post-fader on the Aux Send
pages (see page 80) or the Aux View pages (see page 83).
Change from Variable to Fixed
All set to nominal
All turned off
Aux Sends
Change from Fixed to Variable
All set to –
All set to Post
All turned on
02R96—Owner's Manual
79