12 Monitoring & Talkback; Control Room Monitoring - Yamaha 02R96 Owner's Manual

114
Chapter 12—Monitoring & Talkback
12 Monitoring & Talkback

Control Room Monitoring

The CONTROL ROOM MONITOR OUT uses balanced 1/4-inch
phone jacks, nominal level +4 dB. Typically it's used to feed the control
room's main monitors.
The Control Room Monitor signal source is selected by using the CON-
TROL ROOM buttons.
[2TR D1]: Selects the 2TR IN DIGITAL AES/EBU 1.
[2TR D2]: Selects the 2TR IN DIGITAL COAXIAL 2 .
[2TR D3]: Selects the 2TR IN DIGITAL COAXIAL 3 .
[2TR A1]: Selects the 2TR IN ANALOG 1 .
[2TR A2]: Selects the 2TR IN ANALOG 2 .
[STEREO]: Selects the Stereo Out.
[ASSIGN 1]: Selects the Output Channel assigned to this button on the Control Room
Setup page. See "Control Room Setup" on page 115.
[ASSIGN 2]: Selects the Output Channel assigned to this button on the Control Room
Setup page. See "Control Room Setup" on page 115.
The level of the Control Room Monitor signal can be set by using the
CONTROL ROOM LEVEL control. The [DIMMER] button activates
the Dimmer function, which dims the Control Room Monitor and Sur-
round Monitor signals by the amount specified on the Control Room
Setup page (page 115). The Dimmer function is activated automatically
when the Talkback or Oscillator function is active.
PHONES
0
PHONES
LEVEL
02R96—Owner's Manual
The Control Room Monitor signal is also fed to the PHONES jack, the level of
which is set by using the PHONES LEVEL control.
10
CONTROL ROOM
2TR D1 2TR A1
2TR D2 2TR A2
2TR D3 STEREO
ASSIGN 1 ASSIGN 2
0 10
CONTROL ROOM LEVEL
DIMMER TALKBACK