Input Channels; Patching Input Channels; Metering Input Channels; Reversing The Signal Phase - Yamaha 02R96 Owner's Manual

7 Input Channels

Patching Input Channels

AD Inputs, Slot Inputs, internal effects processor outputs, Digital or Analog 2TR Inputs,
Bus Outs, or Aux Sends can be patched to the Input Channel Inputs. See "Patching Input
Channels" on page 52 for more information.

Metering Input Channels

Input Channel signal levels can be metered on the Meter pages. See "Metering" on page 87
for more information.

Reversing the Signal Phase

The signal phase of each Input Channel can be reversed as follows.
Use the SELECTED CHANNEL DISPLAY ACCESS [PHASE/INSERT] button to
1
select the Phase pages.
The Phase parameters for the 56 Input Channels are divided between two pages. The Input
Channel 1–48 Phase page is shown below. The layout of the other page is the same.
Use the cursor buttons or Parameter wheel to select the NOR/REV buttons,
2
and the [ENTER] button and INC/DEC buttons to set them.
The NOR/REV buttons can also be selected by using the LAYER and [SEL] buttons.
GLOBAL NOR/REV: These buttons allow you to set the phase of all Input Channels
simultaneously.
59
Input Channels
02R96—Owner's Manual