Connecting Studio Manager / M7Cl Editor; Editor Setup; Simple Pc <-> M7Cl Via Network Port 1 - Yamaha M7CL Quick Start Manual

The virtual effects rack. remote ha connection. editor connection guide. using scenes, patching monitor out, accessing outport delays

Hide thumbs Also See for M7CL:

Table of Contents

Connecting Studio Manager / M7CL Editor:

Editor setup; simple PC <-> M7CL via network port 1.

M7CL scene memories and libraries can be stored and edited away from the console in a suitably equipped

computer running M7CL Editor software. The computer can be linked to M7CL and data transferred between

the two via the Ethernet ports and also data synchronization is possible allowing the computer to act as a remote

controller for M7CL.

Software

Get the latest software downloaded free from;

http://www.yamahaproaudio.com/downloads/index.html

Hardware

Minimum requirements for the PC are;

- Windows XP . (Home or Professional)

- 800 MHz Intel Pentium/Celeron processor

- 256 MB available memory

- 30 MB hard disk space

- 1024 x 768 high color display

It is necessary to download;

1) Studio Manager Host program,

2) M7CL Editor, and

3) DME-N network driver.

and install them by following the onscreen instructions.

Access the NETWORK pop-up from the SETUP page. This gives; IP ADDRESS, GATEWAY ADDRESS, SUBNET

MASK and MAC ADDRESS. Note only Class C addresses are supported.

CAT-5 crossover cable

11/20

M7CL Quick Start Guide Part 2

Table of Contents