Water Intrusion Alarm - Huawei FusionModule 1000B Maintenance Manual

FusionModule1000B Air-Cooled IT Solution
Maintenance Guide

5.8 Water Intrusion Alarm

Fault
Category
Water
Intrusion
Alarm
Issue 02 (2017-01-10)
Alar Symptom
m
Sever
ity
Gener There is no water
al onsite.
There is water
onsite.
The water sensor is
covered by
condensate water.
Condensate water
cannot be drained.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Possible Troubleshooting
Cause
The water For details, see
sensor is faulty. Replacing a Water
Sensor (Rope Type)
6.3.2 Replacing a Water
Sensor (Point
A pipe is Contact Huawei
damaged. technical support.
A humidity Replace by following
water refill pipe instructions in
is damaged.
Replacing the
Humidifier Water Refill
Pipe for a Precision Air
Conditioner.
The condensate Replace by following
drainpipe is instructions in
damaged. Replacing the
Condensate Drainpipe of
a Precision Air
Conditioner.
The condensate Remove the drainpipe
drainpipe is outside the container,
blocked. and dig out the material
blocking the pipe using a
thin iron wire.
The Replace the dehumidifier
drainpipe.
dehumidifier
drainpipe is
damaged.
The thermal Replace by following
insulation layer instructions in
is damaged. Replacing a Thermal
Insulation
The humidity is Dehumidify the
too high. FusionModule1000
using a dehumidifier.
The condensate Remove foreign matters
drainpipe is using a thin iron wire or
blocked or remove the ice.
5 Alarms and Faults
6.3.3
or
Type).
6.2.7.1
6.2.7.2
6.2.6
Layer.
62