Replacing A Vcn500 - Huawei FusionModule 1000B Maintenance Manual

FusionModule1000B Air-Cooled IT Solution
Maintenance Guide
Figure 6-28 Removing screws that secure the camera to its base
Step 3 Remove the network cable and take out the camera.
Step 4 Install the new camera by following instructions in documents delivered with the camera,
tighten the screws to secure the camera to its the base, and reconnect the network cable in the
original way.
Step 5 Adjust the angle of the camera to cover the monitored area by following instructions in
documents delivered with the camera, and reinstall the transparent cover.
Step 6 Configure the camera by referring to the management system initial configuration table in the
initial configuration parameter manual for the solution in use.
Step 7 Check that the new camera is working properly.
----End
Follow-up Procedure
Dispose of the removed camera that is confirmed faulty.

6.3.9 Replacing a VCN500

Prerequisites


Issue 02 (2017-01-10)
The original parameter settings can be used.
A VCN500 needs to be replaced.
A spare VCN500 of the same model is available and functional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Parts Replacement
109