Replacing A Fingerprint Scanner - Huawei FusionModule 1000B Maintenance Manual

FusionModule1000B Air-Cooled IT Solution
Maintenance Guide

6.3.13.5 Replacing a Fingerprint Scanner

Prerequisites


Impact on the System
None
Preparations
Tools: Phillips screwdriver, protective gloves
Materials: spare fingerprint scanner
Documents: documents delivered with the fingerprint scanner, management system initial
configuration table, power supply and distribution system diagram
Skill requirement: weak-current engineer
Procedure
Step 1 Switch off the access controller circuit breaker in the PDB.
Step 2 Remove screws securing the fingerprint scanner, and remove cables, as shown by (1), (2), and
(3) in
Figure 6-41 Replacing a fingerprint scanner
Step 3 Remove the base plate of the new fingerprint scanner, as shown by (4) and (5) in
Step 4 Connect cables, as shown by (6) in
Step 5 Fix the fingerprint scanner onto the base plate, as shown by (7) and (8) in
Step 6 Switch on the access controller circuit breaker in the PDB.
Step 7 Configure the fingerprint scanner by referring to the management system initial configuration
table and documents delivered with the fingerprint scanner.
Issue 02 (2017-01-10)
A finger print scanner needs to be replaced.
A spare finger print scanner of the same model is available and functional.
For the diagrams and tables, see the initial configuration parameter manual for the solution in use.
Figure 6-41.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 6-41.
6 Parts Replacement
Figure 6-41.
Figure 6-41.
123