Table of Contents
Advertisement
FILTR Revolution
Once the filters have been installed, replace the top section of the Revolution unit.
Ensure that the keyed sections of the unit mate up properly.
The panel seams on the upper section of the unit will seat onto these keyed sections.
Rotating the upper section 180 degrees will seat it the same (if the wall or ceiling
mounts are installed, be sure to align them properly). The unit needs to seat together
properly to prevent unfiltered air from leaking in.
Reset the Pre-Filter Timer
After successfully re-assembling the unit, apply power and turn the unit on.
Resetting the Pre-Filter timer can be accomplished on the unit itself by pressing the (+)
button on the keypad for three seconds. This will turn the LED off and reset the timer to
zero.
248083486-1 R2
Figure 6-6
Figure 6-7
Operators Manual
Note the keyed sections
of the Filter Tray.
There are two pairs of
them on opposite sides
of the tray.
Panel seams will line up,
indicating the two
sections are properly
aligned.
55
Advertisement
Table of Contents
