Powering On The Unit - FILTR Revolution User Manual

FILTR Revolution

Powering on the Unit

The power cable for the Revolution unit
comes shipped inside the upper
compartment of the unit. Flip up the four
latches around the top cover, remove the
top cover (see Figure 2-6), and obtain the
cable from the inner cavity. Re-install the
top cover before proceeding.
The Revolution unit comes with all ordered filters installed. To begin running the unit,
locate the power port on the side of the unit above the Filter Tray.
Attach the supplied power cord to the unit and a
power source.
Flip the power switch to the ON position.
On the keypad, press the (+) button to cause the
fan to start and the unit will begin pulling air
through and filtering it.
See Chapter 3, Using the Keypad, for instruction on using the keypad to control the unit,
including activating the Ionizer and setting the unit up for wifi communication.
See Chapter 4, Using the FILTR app, for instruction on connecting the unit to the FILTR
app and using the app to control the unit.
248083486-1 R2
End Of Chapter
Operators Manual
Figure 2-5
ON
OFF
Figure 2-6
11