Table of Contents
Advertisement
FILTR Revolution
3 Using the Keypad
The Revolution unit comes with a physical interface consisting of six LEDs and two
buttons.
With the Revolution unit plugged in and turned on, the Keypad can be used for a variety
of functions, including:
• Controlling the fan speed
• Turning the ionizer on and off
• Indicating filter status based on pre-determined lifespans and resetting the filter
• Setting the unit into AP mode for connecting wireless devices
When the unit is connected to the FILTR app for wireless control, the keypad will be
overridden by the commands from the app. This allows the unit to be placed in harder-
to-reach areas without the user needing physical access to the unit to control it.
Controlling the Fan Speed
The + and – buttons on the interface allows the user to
increase and decrease the speed of the units internal
blower, thereby increasing the airflow through the
Revolution unit.
Four speeds are available using this interface: Off, Low,
Medium, and High. Each momentary button press
increments or decrements the speed by one step.
If the Ionizer is turned off, the LEDs will illuminate as
shown in Figure 3-2.
248083486-1 R2
life timers
Figure 3-1
Operators Manual
Figure 3-2
13
Advertisement
Table of Contents
