Table of Contents
Advertisement
FILTR Revolution
Connect the Unit Brackets
The first step in installing the Wall Brackets is to determine which side of the Revolution
unit will be towards the wall. It is suggested to keep both the side with the Keypad and
the side with the Power Port away from the wall for viewing and access, respectively.
Once the side facing the wall is determined, place the Upper Unit Bracket on top of the
Revolution with the mounting face towards the "wall side" of the unit. Secure the
bracket to the unit using three of the Unit Bracket screws (see Figure 5-1 for proper
screw).
Lay the Revolution unit on its side and remove the Pedestal from the bottom of the unit
by removing the four screws holding it to the base.
Remove 4 screws
Figure 5-3
Using three of the Unit Bracket screws, install the Lower Unit Bracket onto the bottom
of the unit, ensuring that the mounting face is towards the chosen "wall side" of the
unit.
248083486-1 R2
Face towards the "wall-side"
Figure 5-2
Figure 5-4
Operators Manual
Install 3 screws
Face towards "wall side"
43
Advertisement
Table of Contents
