Table of Contents
Advertisement
FILTR Revolution
Connecting one of the Mounting Kits while using the Duct Adapter is fairly simple.
Determine the "wall side" or "ceiling side" of the unit, remove the three screws that
correspond to the holes in the mounting bracket, then install the mounting bracket on
top of the Duct Adapter.
Duct Adapter with Ceiling Mount Bracket
Figure 5-18
Install Lower Duct Adapter
Lay the Revolution unit on its side and remove the Pedestal from the bottom of the unit
by removing the four screws holding it to the base. Install one of the Duct Gaskets over
the mounting holes, then secure a Duct Adapter to the unit using five of the supplied
screws, as one of the mounting options will also be installed.
Remove 4 screws
248083486-1 R2
Figure 5-20
Duct Adapter with Wall Mount Bracket
Figure 5-19
Leave 3 open,
corresponding to
desired
mounting option
Figure 5-21
Operators Manual
49
Advertisement
Table of Contents
