Wifi Access Point Provision - FILTR Revolution User Manual

Operators Manual

WiFi Access Point Provision

The keypad must be used to initially set the unit into connection mode so that the Wifi
can be configured, enabling the user to communicate with the unit via the FILTR app.
The Status LED on the keypad displays the current state of the wireless connection,
while the middle Fan Speed LED doubles as the Access Point Provisioning mode
indicator.
Status LED:
LED Off: The WiFi router is not connected to an access point
LED blinking at 1Hz (once per second): Unit in Access Point Provisioning mode
LED blinking at 4Hz (4 times per second): Unit connected to Access Point
LED On: Unit connected to End Point (i.e. cloud server)
Changing WiFi Status
The unit can be connected to an Access Point and set up to communicate with the FILTR
app.
To initially set up the Revolution unit to connect to an Access Point follow these steps:
1. Ensure that the Revolution unit is not already connected to an access point (WiFi
Status LED will be Off).
2. Hold down both the (+) and (-) buttons until only the center Fan Speed LED
illuminates (will take 5 seconds) then release the buttons.
3. This will put the unit into Access Point Provisioning mode, and the Status LED will
begin blinking at a rate of 1Hz (once per second).
16
Figure 3-6
FILTR Revolution
Access Point Provision
248083486-1 R2