Adding A Device - FILTR Revolution User Manual

Operators Manual

Adding A Device

At this point, the Revolution unit needs to be connected to a Wifi Access Point. See the
"WiFi Access Point Provision" section of Chapter 3 for setting up the Revolution unit for
communication with the FILTR app.
There are two ways to add a new Revolution device to the FILTR app: Using the
button on the Home screen or using the Add & Share FILTRs screen.
Press the
the "SCAN QR CODE" button. If the FILTR app does not yet have permission to use the
camera, the PERMISSIONS button will be shown to assist in gaining that permission.
Alternatively, select the More Options icon from the bottom right of the screen. Select
Add & Share FILTRs from the menu that pops up, then select the "SCAN QR CODE"
button that is available. If the FILTR app does not yet have permission to use the
camera, the PERMISSIONS button will be shown to assist in gaining that permission.
Add Device
button
Add & Share
FILTRs
The smartphone will go into camera mode and be ready to scan the QR code located on
the Revolutions Serial Label. This QR code is unique to the Wifi board contained inside
the unit. Once the unit is paired to a particular user this way, that user becomes the
Admin for the Revolution device, and no other user can scan and pair the device to their
login. The Admin can share the device (see "More Options: Add & Share Devices"
section later in this chapter), but will have to delete the device before a new Admin can
exist.
NOTE: It is recommended to keep the Admins login on
record to facilitate Admin record changes, sharing, and
access.
The QR code is located on the Serial Label, which is
located above the power connection port on the
Revolution unit.
22
button from the Home screen to bring up the Add FILTR screen, then press
Figure 4-5
FILTR Revolution
Figure 4-6
Figure 4-7
248083486-1 R2