Adjusting The Rear X Belt Tension - GRAPHTEC FCX4000 Service Manual

7 DISASSEMBLY AND ASSEMBLY
7.4.4

Adjusting the Rear X Belt Tension

(1) Detach the right rear corner cover (Refer to the section 7.1.2.).
(2) Detach the left rear corner cover (Refer to the section 7.1.4.).
(3) Detach the left top cover (Refer to the section 7.1.6.).
(4) Detach the rear top cover (Refer to the section 7.1.10.).
(5) Detach the X flexible cable cover (Refer to the section 7.1.11.).
(6) Detach the rear bottom cover (Refer to the section 7.1.12.).
(7) Remove the seven M3L6 binding head screws holding the rear X belt cover, and then detach it.
Rear X belt cover
M3L6 binding head screw
(8) Detach the right rear corner cover (Refer to the section 7.1.2.).
(9) Detach the left rear corner cover (Refer to the section 7.1.4.).
(10) Detach the rear top cover (Refer to the section 7.1.10.).
(11) Detach the rear bottom cover (Refer to the section 7.1.12.).
(12) Loosen the two M4L6 binding head screw fixing the idler bracket.
Idler bracket
Idler bracket
Rear X belt
M4L6 binding head screw
M4L6 binding head screw
Rear X belt
Use this access hole to loosen the screw of front.
FCX4000-UM-251-9370 7-48