GRAPHTEC FCX4000 Service Manual page 191

12 Target electrical component for WEEE instruction
(5) Remove the studs from the main board.
• Control Panel Board (B)
(6) Remove the two M4L8 binding head screws holding the left front corner cover, and then detach it.
Left front corner cover
M4L8 binding head screw
(7) Remove the seven M4L8 binding head screws holding the left side cover, and then detach it.
M4L8 binding head screw
Left side cover
M4L8 binding head screw
(8) Release the cable ties holding the cables, and then pull out the cable from the left side main frame.
Pull out the cables from here.
Cable tie
FCX4000-UM-251-9370 12-5