Setting The Tool Condition - GRAPHTEC FCX4000 Service Manual

3.7.2

Setting the Tool Condition

This section describes how to make the tool, speed, force, acceleration, and tool number settings.
Before cutting media, the following four cutter pen conditions must be specified.
• OFFSET
• SPEED
• FORCE
• ACCELERATION
Setting the Tool
(1) Press the [COND/TEST] key from READY status.
CONDITION setting screen (1/4) is displayed.
(2) Press the [2] key (TOOL).
TOOL setting screen is displayed.
(3) Press the POSITION (▲▼) keys, and set the tool.
(4) Press the [3] key (OFFSET).
OFFSET setting screen is displayed.
(5) Press the POSITION (▲▼) keys and increase or decrease the setting value.
(6) Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/4).
(7) Press the [COND/TEST] key.
It will return to default screen.
FCX4000-UM-251-9730 3-18
3. OPERATIONS