Y Flexible Cable - GRAPHTEC FCX4000 Service Manual

7.3.8

Y Flexible Cable

How to detach the Y Flexible Cable
(1) Detach the Y bar cover (Refer to the section 7.1.13.).
(2) Detach the rear Y bar end cover (Refer to the section 7.1.16.).
(3) Disconnect the Y Flexible cable from the Y relay board.
(4) Disconnect the Y Flexible cable from the pen board.
(5) Gently peel off the Y Flexible cable from the Y bar and the Y cable bracket.
How to reinstall the Y Flexible Cable
(1) Reattach the Y flexible cable in the reverse order in which it was detached.
(2) Move the pen block to front end of Y bar until it hit to the front stopper.
(3) Make the 5 mm slack between the turning end of Y flexible cable and the pen board as shown in above
picture.
FCX4000-UM-251-9370
Y flexible cable
Y relay board
5 mm
7 DISASSEMBLY AND ASSEMBLY
Pen board
Y Flexible cable
7-40