Auto Function Operating Modes - Basler Racer User Manual

AW00118508000
8.5.2

Auto Function Operating Modes

The following auto function modes of operation are available:
"Once" mode of operation: When this mode of operation is selected, the parameter values are

automatically adjusted until the related image property reaches the target value. After the
automatic parameter value adjustment is complete, the auto function will automatically be set
to Off.
The parameter value can be changed by using the "once" mode of operation again, by using
the "continuous" mode of operation, or by manual adjustment.
If an auto function is set to the "once" operation mode and if the circumstances
will not allow reaching a target value for an image property, the auto function
will try to reach the target value up to 30 times and will then be set to Off.
"Continuous" mode of operation: When this mode of operation is selected, the parameter

value is adjusted repeatedly while lines are acquired.
The repeated automatic adjustment will proceed until the "once" mode of operation is used or
until the auto function is set to Off, in which case the parameter value resulting from the latest
automatic adjustment will operate, unless the parameter is manually adjusted.
Off: When an auto function is set to Off, the parameter value resulting from the latest

automatic adjustment will operate, unless the parameter is manually adjusted.
You can enable auto functions and change their settings while the camera is
acquiring lines ("on the fly").
If you have set an auto function to "once" or "continuous" operation mode while
the camera was continuously acquiring lines, the auto function will become
effective with a short delay and the first few lines may not be affected by the auto
function.
Basler racer Camera Link
Features
111