General Specifications - Basler Racer User Manual

AW00118508000
1.4

General Specifications

Specification
Resolution
Sensor Type
Effective Sensor Diagonal
Pixel Size
Max Line Rate
Min Line Rate
Mono/Color
Sensor Bit Depth
Data Output Type
Connectors
Camera Link Pixel Clock
Speed (Nominal)
Camera Link Tap Geometry
Pixel Formats
Synchronization
Exposure Time Control
Camera Power Requirements
Power Consumption
(typical, at 12 VDC)
I/O Lines
Table 1: General Specifications - 2k and 4k Mono Cameras
Basler racer Camera Link
raL2048-80km
2048 pixels
max. 2040 pixels available with 1X10
tap geometry
Awaiba DR-2k-7
Monochrome Linear CMOS
14.34 mm
7 µm x 7 µm
80 kHz
No minimum when a hardware trigger signal is used
100 Hz when a hardware trigger signal is not used
Mono
12 bit
Camera Link base, medium or full configuration
One 6-pin Hirose micro-miniature receptacle
Two Camera Link 26-pin SDR connectors
(also known as Mini Camera Link connectors)
32.5 MHz, 48 MHz, 65 MHz, 83.5 MHz (selectable; see Section 8.1 on
page 100 for the difference between nominal and actual values)
1X, 1X2, 1X4, 1X8, 1X10
Mono 8
Mono 10
Mono 12
Via hardware trigger signal, via software trigger signal or free run
Programmable via the camera API
PoCL (Power over Camera Link compliant)
or
+12 VDC (-10 %) to +24 VDC (+5 %), < 1 % ripple, supplied via the camera's
6-pin connector.
3 W
4 input lines (CC1 to CC4) and 1 output line (via Camera Link spare bit)
Specifications, Requirements, and Precautions
raL4096-80km
4096 pixels
max. 4080 pixels available with 1X10
tap geometry
Awaiba DR-4k-7
Monochrome Linear CMOS
28.67 mm
4 W
3