Xerox I Class Operator's Manual page 65

Communications (continued)
GATEWAY
SNMPTRAP DESTINATION
PROTOCOL
NETWARE
²ENABLED
DISABLED
DISCOVERY
DHCP
²ENABLED
DISABLED
I-Class
Specifies the network gateway address the
NIC Adapter should use.
Selects the Network IP address where all
SNMP Traps will be sent. If zeroed, no
traps are sent.
The network protocols recognized by the
NIC Adapter.
Allow the printer to be driven from an NDS
Novell Print Queue.
Netware is enabled by default.
Ignore the Netware protocol. Select this
option if Netware is not needed.
This is the address discovery method used
by the NIC Adapter if a static address is
not utilized. If no server for any of the
discovery methods is found, the static
value specified above is used.
þ Note: For faster NIC Adapter boot times,
disable any discovery methods not used.
Dynamic Host
Automatically assign IP address from a
DHCP Server.
DHCP is enabled by default.
WARNING! An IP Address assigned by a DHCP
has precedence over any static IP Address
stored in the NIC Adapter.
Disable DHCP.
þ Note: Select this option to insure any static IP
stored is used by the NIC Adapter.
Control Protocol.
55