Xerox I Class Operator's Manual page 51

Printer Options (continued)
BARCODE COUNT
²00
REDUNDANCY LEVEL
READ BARCODE (1X)
²READ BARCODE (2X)
READ BARCODE (3X)
READ BARCODE (4X)
READ BARCODE (5X)
READ BARCODE (6X)
BUZZER
ENABLED
²DISABLED
SET DEFAULTS
I-Class
(00-99)
Used to set the specific number of barcodes
to be read on the label. 00 selects AUTO
Mode, allowing a variable number of
barcodes to be read per label format.
AUTO Mode should not be used with
imaged (bitmapped) barcodes or with
certain bar code addendums as shown in
Appendix B.
Used to ensure the data integrity of the bar
code. The selected level determines the
number of consecutive, identical decodes
required before passing the bar code (i.e., if
set to three times, the barcode will not pass
until it has decoded the same values three
times in succession.)
þ Note: Depending upon the print speed,
higher verification levels may cause erroneous
failures when scanning multiple bar codes or
bar codes that are small in height.
One decode per barcode.
Two decodes per barcode.
Three decodes per barcode.
Four decodes per barcode.
Five decodes per barcode.
Six decodes per barcode.
Audible signal indicating a 'good' bar code.
þ Note: Disable this function for higher label
throughput speeds.
Enables the buzzer.
Disables the buzzer.
Reset the current settings of the Scanner to
the default settings.
41