Xerox DocuPrint 4050 NPS Message Manual page 97

Message
H355
H356
J021
J023
J024
J025
J026
J028
J067
J125
J144
J145
XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
Convergence timeout
(black toner patch).
Convergence timeout
(color toner patch).
ADIO self test analog
failure.
ADIO self test input
failure.
ADIO self test output
failure.
HCFR self test input
failure.
HCFR self test output
failure.
MC or Real Time ticks out
of spec.
Waste roll bias voltage
out of range.
Patches for charge
control are out of range.
PHR self test input failure.
PHR self test input failure.
Explanation/action
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
No action required.
If problem persists, notify your service representative.
No action required.
If problem persists, notify your service representative.
No action required.
If problem persists, notify your service representative.
No action required.
If problem persists, notify your service representative.
No action required.
If problem persists, notify your service representative.
Machine clocks or real time per pitch is out of tolerance.
No action required.
If problem persists, notify your service representative.
Note: The failure may be caused by speed variations of
the main drive or registration transport that will cause mis-
registration of the print, or intermittent MC sensor or
registration finger switch.
No action required.
If problem persists, notify your service representative.
A charge control error has been detected.
No action required.
If problem persists, notify your service representative.
The PHR board has failed or a PHR input signal line is
shorted to ground.
No action required.
If problem persists, notify your service representative.
There has been a PHR board failure, an off-board problem
in a PHR output device or signal line, or a loss of + 24 V.
No action required.
If problem persists, notify your service representative.
PRINTER CONTROLLER MESSAGES
48-33