Xerox DocuPrint 4050 NPS Message Manual page 81

Network printer series
Hide thumbs Also See for DocuPrint 4050 NPS:
Table of Contents

Advertisement

Message
E124
E126
E131
E134
E138
E139
E223
E224
E225
E226
XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
Both paper trays low on
paper.
Late arrival at pre-
transfer feeding from
HCF.
Low toner in the system.
Low toner detected by
toner sensor.
Late arrival at output tray
switch while inverting.
Early arrival at output tray
switch while inverting.
Clear entire IOT paper
path and HCF paper path.
HCF vertical transport
lead edge jam.
HCF vertical transport
trail edge jam.
Bottom transport leading
edge jam.
Explanation/action
1. Close the left door.
2. Press the Continue button.
The paper is too low, or the unlock button has been
pressed for both trays you selected.
1. Open any selected tray.
2. Load and close the paper tray.
3. Press the Continue button.
The paper failed to arrive at the pre-transfer jam switch
while feeding from the HCF in the allotted amount of time.
1. Clear area 2
2. Press the Continue button.
The dry ink is too low as determined by the system.
1. Add dry ink.
2. Close the left front door.
The dry ink is too low as determined by the dry ink sensor
(displayed at the end of the jam).
1. Add dry ink.
2. Close the left front door.
The paper failed to arrive at the output tray jam switch
while inverting in the allotted amount of time.
1. Clear area 5.
2. If fault persists, check fuser for an accordion jam.
3. Press the Continue button.
The paper arrived early at the output tray jam switch while
inverting.
1. Clear area 5.
2. Press the Continue button.
A job has not printed and completed a purge sequence.
Clear the entire paper path.
The paper fed from one of the trays did not reach the
vertical transport jam switch within the allotted time.
1. Clear area 1a.
2. Press the Continue button.
The paper fed from one of the trays did not leave the
vertical transport jam switch within the allotted time.
1. Clear areas 1a and 2a.
2. Press the Continue button.
The paper fed from the HCF did not reach the bottom
transport switch in time.
PRINTER CONTROLLER MESSAGES
48-17

Advertisement

Table of Contents
loading

Table of Contents