Xerox DocuPrint 4050 NPS Message Manual page 31

Message
C069
C070
C071
C072
C073
C074
C075
XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
Queuing is Started.
Scheduling Policy: resourceMatch
PS-admin>
Paper tray 3 fault -- Select
another tray.
Check paper supply in
tray 3.
Tray 3 wait station sensor
not made, but SFRS
made.
Sheet did not clear tray 3
wait station sensor.
Tray 3 feeder failed to
feed sheet from stack to
SFRS.
Tray 3 has low paper.
Tray 3 down due to
unlock button being
pressed.
Explanation/action
The tray 3 elevator has not reached the end of its travel in
9 seconds.
1. Open the HCF front door.
2. Open and close tray 3.
3. Close the HCF front door.
The stack height sensor does not see paper.
1. Clear the tray 3 feeder.
2. Load and close paper tray 3.
3. Press the Continue button.
The paper failed to reach the wait station sensor in time, or
there was no paper at the wait station when attempting to
feed.
1. Clear the tray 3 feeder.
2. Press the Continue button.
1. Clear the tray 3 feeder.
2. Press the Continue button.
The feeder failed to move a sheet from the stack to the
stack force relief sensor within the allotted time.
1. Clear the tray 3 feeder.
2. Fan the copy paper stack (tray 3).
3. Load and close paper tray 3.
4. Press the Continue button.
The tray 3 elevator was raised with insufficient paper, or
the paper supply was nearly depleted during printing.
1. Clear the tray 3 feeder.
2. Load and close paper tray 3.
3. Press the Continue button.
The tray 3 unlock button was pushed, and the tray is down.
1. Open tray 3.
2. Load and close tray 3.
3. Press the Continue button.
PRINTER CONTROLLER MESSAGES
48-11