Xerox DocuPrint 4050 NPS Message Manual page 50

PRINTER CONTROLLER MESSAGES
Message
H128
H129
H130
H132
H133
H138
H241 -
F4050
H241 -
F4850
H304
H306
H307
48-30
Toner waste bottle full.
Patches for toner control
are out of range.
Ozone system failure.
No process control
convergence after power
up.
Light patches; however,
toner bottle sensor
indicates presence of
toner in bottle/hopper.
Failure to detect a
transition of waste or
reclaim auger in 3
seconds.
Set separator sensor or
solenoid failure.
XAN failed memory or
communications test.
Cleaner air pressure
indicates blockage.
Black developer waste
tube blocked.
Color developer waste
tube blocked.
Explanation/action
The dry ink waste bottle is too full.
1. Press the Continue button.
2. If problem persists, notify your service representative.
The process control patch used to control the toner
dispenser was returned as white, six times in a row.
1. Press the Continue button.
2. If problem persists, notify your service representative.
The ozone blower activation switch has failed.
1. Press the Continue button.
2. If problem persists, notify your service representative.
The charge current is out of tolerance.
1. Press the Continue button.
2. If problem persists, notify your service representative.
1. Power the system off and back on.
2. If the problem persists, notify your service
representative.
No action required.
If problem persists, notify your service representative.
A set separator sensor or solenoid failure has been
detected
1. Press the Continue button.
2. If problem persists, notify your service representative.
The XAN has failed the memory test or the
communications test.
1. Press the Continue button.
2. If problem persists, notify your service representative.
A blockage in the cleaner has been detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
A blockage in the black developer waste tube has been
detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
A blockage in the color developer waste tube has been
detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE