Error Signalling; Display - Error Messages - Zetor FORTERRA HSX 120 Operator's Manual

Error signalling

Errors arising during tractor operation are indicated by
switching the corresponding signal lamp, acoustic signal
and error message in the instrument panel display.
If the error is indicated, the signal lamp still glows, even
though the display is switched to the next display.
If the error is not eliminated or the indicated state has not
returned to a normal state:
the corresponding signal lamp glows
when the tractor is switched off, the key in the switch box
is moved to position I and then the engine is started, the
corresponding signal lamp is switched on again and the
error message runs through the display.
1 - The signal lamp of a serious defect of the system (red).
2 - The signal lamp of a less serious defect of the system
(orange).
3 - Operational protection signal lamp (blue).

Display - error messages

During tractor operation, three types of error messages may appear in the display.
A. - Warning of operational protection,
that a small deviation from the set values or error by the operator occurred.
The warning is displayed in the display for about 10 seconds and then the display is switched to the
previously set main screen.
The state is indicated by the signal lamp
The tractor can be used without limitation.
B. - Less serious defects of the system
If a less serious defect of the system occurs, the defect number is displayed in the display for about 10
seconds. Then the display of the defect is minimized into the main field.
All the tractor's functions remain active; it can happen that some of the functions is not undepreciated.
The state is indicated by the signal lamp
If this situation occurs, finish the work and contact the service centre.
C. - Serious defects of the system
The display cannot be switched to another screen.
The state is indicated by the signal lamp
If this situation occurs, stop the tractor immediately and contact the service centre.
68
INSTRUMENT PANEL
P18N048