Shape The Beam - ETC Source 4WRD Color Installation And User Manual

Set the Angle within the Yoke
1. Loosen the yoke locking knob. Do not
remove the knob.
2. Tilt the fixture to the desired position.
3. Tighten the yoke locking knob to secure
in position.

Shape the Beam

You can shape the beam by using the shutters, a pattern, an optional
drop-in iris, and by rotating the barrel.
Use the Accessory Holder
The accessory holder is equipped with a spring-loaded retaining clip that
prevents color frames and accessories from falling out.
WARNING:
in position with the retaining clip before hanging the fixture.
AVERTISSEMENT :
verrouillés en place à l'aide du verrouillage de la cassette
avant de suspendre le projecteur.
1. Release the retaining clip by pushing it
sideways while gently pulling backwards.
2. Insert the color frame or accessory.
3. Lock the retaining clip by pushing
sideways while gently pushing forward.
Use a Pattern
The pattern holder slot is on the top side of the barrel and in front of the
shutters. It accommodates A-size, B-size, and glass pattern holders.
Because the Source 4WRD Color fixture aperture is 3 inches wide, ETC
recommends A-size patterns for maximum effectiveness.
A-size pattern holder:
Holds 7.6 cm (3 in)
diameter patterns
16
Make sure all color frame accessories are locked
S'assurer que tous les porte-filtres sont
7.93 cm
(3.12 in)
diameter
9.4 cm
(3.7 in)
Source 4WRD Color Installation and User Manual
Yoke locking
knob
Retaining
B-size pattern holder:
7 cm
Holds 6.35 cm (2.5 in)
(2.75 in)
diameter
and 7 cm (2.75 in)
diameter patterns
9.4 cm
(3.7 in)
clip