Install The Fixture; Attach C-Clamp And Safety Cable - ETC Source 4WRD Color Installation And User Manual

Install the Fixture

Source Four lens tube

Attach C-clamp and Safety Cable

The C-clamp attaches the fixture to the mounting pipe and allows you to
adjust the position of the mounted fixture. ETC recommends using 1.5 in
schedule 40 pipe.
1. Tightly fasten the C-clamp to the yoke with the provided yoke bolt
and lock washer.
2. Place the C-clamp on mounting pipe, and then tighten the pipe
bolt to secure it.
3. Loosen the C-clamp pan screw and rotate the yoke to the desired
position.
4. Tighten the pan screw to lock the fixture.
5. Connect the safety cable.
6. Tighten the C-clamp pipe bolt to 15–20 ft-lb (20–27 Nm),
approximately finger tight plus up to one-quarter turn.
CAUTION:
the C-clamp pipe bolt. Do not use excessive force.
7. Tighten the yoke pivot bolt to 5–10 ft-lb (6–7 Nm), approximately
finger tight plus up to one-eighth turn.
CAUTION:
the yoke pivot bolt. Do not use excessive force.
10
Adjustable yoke
(not included)
Shutters (x4)
Do not exceed 25 ft-lb (33 Nm) while tightening
Do not exceed 15 ft-lb (20 Nm) while tightening
Source 4WRD Color Installation and User Manual
Retrofit
Cat5 cable
strain relief
Yoke locking knob
Attached power lead