ETC Source 4WRD Color Installation And User Manual page 11

CAUTION:
other than oil-free canned air.
Tools required:
Adjustable wrench
•
#2 Phillips screwdriver
•
1. Use oil-free canned air to clean the LED emitters before you install
the retrofit. Do not touch the LED emitters.
2. With the fixture resting securely on a flat surface, attach the
supplied threaded post to the back end of the fixture body. Use an
adjustable wrench to tighten the threaded post one-quarter turn
past finger tight.
3. Gently slide the Source 4WRD Color onto the fixture body and
threaded post while guiding the LED tower into the lamp housing
hole, as shown in the following image. Take care to prevent contact
between the LEDs and the reflector.
Source Four
fixture body
4. Use a #2 Phillips screwdriver to tighten the screw located on the
back end of the Source 4WRD Color, directly above the
Z-adjustment knob.
5. Pull gently to verify secure attachment.
6. Set the Z-adjustment using the Z-adjustment knob. See
adjustment on page 15
Source 4WRD Color Installation and User Manual
Do not touch or clean LED emitters with anything
Lamp
housing
hole
.
Insert threaded
post here
Tighten
screw
Z-adjustment
knob
Set the Z-
7