Clean The Reflector - ETC Source 4WRD Color Installation And User Manual

Clean the Reflector

WARNING:
clean the reflector.
AVERTISSEMENT :
refroidir avant de nettoyer le réflecteur.
1. To protect the lamp housing during cleaning, remove the LED lamp
housing by loosening the attachment screw and pulling the
housing straight out. (See image on
2. Remove the barrel rotation knob located at the bottom of the
barrel. Use a Phillips screwdriver to remove the retaining bolt
located on top of the reflector housing.
3. Rotate the barrel 45° in either direction. Carefully remove the
barrel from the reflector housing.
4. Remove the diffusion from in front of the reflector. Remove any
dust from the diffusion with a blast of oil-free air or wipe with a
clean, lint-free cloth.
5. Clean the reflector. Remove any dust with a blast of oil-free air or
wipe with a clean, lint-free cloth. You can use isopropyl alcohol,
distilled water, or a 50%-50% mixture of each to clean the glass
surface.
6. Insert the diffusion into the reflector housing with the dull side of
the diffusion facing the lamp and the shiny side facing out.
7. Insert the barrel into the reflector housing with the iris/pattern slot
on top. Align the triangles on both parts.
8. While gently pressing in, rotate the barrel 45° clockwise until it
sets into position, and then rotate the barrel counterclockwise 45°.
The barrel should be firmly attached and the triangles should be
aligned.
9. Reinstall the barrel rotation knob and tighten the retaining bolt.
10. Reinstall the LED lamp housing and tighten the attachment screw.
See Install the Source 4WRD Color Retrofit on page 6
Source 4WRD Color Installation and User Manual
Unplug the fixture and allow it to cool before you
Débrancher le projecteur et le laisser
page 7
.)
.
21