Remove Incandescent Lamp Housing; Install The Source 4Wrd Color Retrofit - ETC Source 4WRD Color Installation And User Manual

Remove Incandescent Lamp Housing

1. Unplug the Source Four incandescent fixture and place it on a flat,
stable surface.
2. Loosen the brass thumb screw located above the beam adjustment
knob. The lamp housing is now loose.
3. Remove the lamp housing from the fixture body.
Note:
ETC to recycle the burner assembly, contact ETC Technical Services
for more information. See
page 2.

Install the Source 4WRD Color Retrofit

WARNING:
only onto luminaires that have the construction features and
dimensions shown in the images in this document and where
the input rating of the retrofit kit does not exceed the input
rating of the luminaire.
AVERTISSEMENT :
ÉLECTRIQUE! N'installer ce kit que sur les projecteurs qui ont
les caractéristiques de construction et les dimensions
indiquées sur les images de ce document et où la puissance
électrique nécessaire à la conversion n'excède pas la puissance
maximale du projecteur.
WARNING:
enclosure of wiring or electrical components during kit
installation.
6
The burner assembly is no longer needed. If you would like
RISK OF FIRE OR ELECTRIC SHOCK! Install this kit
RISQUE D'INCENDIE OU DE DÉCHARGE
Do not make or alter any open holes in an
Source 4WRD Color Installation and User Manual
Help from ETC Technical Services on