Swath Width Adjustment - SaMASZ KDC 260 Operator's Manual

NOTE:
Due to various swath widths in offered mowers (and therefore various turns
of discs), before mounting the knives first check turns of each disc (Fig. 21–
Fig. 26).
NOTE:
Improper mounting of knives will lead the mower to choke. When mounting
pay particular attention to knife rotating freely on the holder's pin.
NOTE:
Due to high rotary speed of discs, knife holders should be replaced in sets
and feature the same weight – each holder has its own weight marked.
Otherwise, it is highly likely that due to improper balancing, disc vibrations
and damages to bearings will occur.

6.4. Swath width adjustment

In order to set swath width adjust swath guides (1) (Fig. 27) (Models: : KDC S/SL):
loosen eye screw (2) on swath guide,
set swath guide (1) as required,
tighten bolt (2).
Fig. 27. Adjusting of swath guides: 1- swath guide, 2 - adjustment bolt
In order to set swath width adjust swath guides (1) (Fig. 28) (Models: KDC W):
loosen eye screw (2) of swath guide,
set swath guide (1) as needed,
tighten bolt (2).
Operator's manual
1
- 32 -
Trailed disc mowers
KDC
1
2