Stapling; Staple Placement - Xerox WorkCentre Pro 75 Operator's Manual

Operator Guide
Edge Feed
Orientation Media Size
Long 8.5x11
Long 8.5x14
Short 8.5x11
Short 8.5x14
Short 11x17
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX

Stapling

Removing any of the output while the printer is running may
produce finished sets that are incorrectly stapled.
To ensure that the stapling of thin sets is satisfactory, the printer
performs the following actions.
After 30 finished sets of 15 sheets, the printer:
1. cycles down
2. raises a message to empty the Stacker
3. waits until the sets are removed
4. raises the Stacker Tray
5. cycles up and resumes printing.
If these parameters are not satisfactory for your printing, contact
Xerox.

Staple placement

For information about the limitations of portrait and landscape
staple placement, refer to the Staple Placement table below.
Table 3-1. Staple placement
Portrait Landscape
Staple Staple
FAULT
N/A N/A
FAULT
FAULT
FAULT
Dual Dual
Portrait Landscape
Staple Staple
FAULT
N/A N/A
FAULT
FAULT
FAULT
Product overview
3-11