Xerox WorkCentre Pro 75 Operator's Manual page 44

Maintenance
4-2
Figure 4-1. Ultra 10/Ultra 30 controller power-on button and
LED
Figure 4-2. SunBlade 150 controller power-on button and
LED
To power on the controller:
1. Switch on the power for each of the connected peripherals.
2. Switch on the monitor.
3. Press the controller "On" button.
4. Confirm that the controller LED light is on.
NOTE: For an Ultra 10, you need to power off the system from
the back of the controller.
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
Operator Guide
Power
On/Off
and
LED
Power
On/Off
and
LED