Printer Faults; Clearing Printer Faults; Paper Jams - Xerox WorkCentre Pro 75 Operator's Manual

Maintenance

Printer faults

Clearing printer faults

Paper jams

4-10
• The power cable is damaged or frayed.
• A wall panel circuit breaker, fuse, or other safety device has
been tripped.
• Liquid is spilled into the equipment.
• The equipment is exposed to water damage or flood.
• Any part of the equipment is physically damaged.
Occasionally, a fault will occur at the printer that may prevent you
from using the printer, such as:
• Out of Paper
• Low Dry Ink
• Module/Cartridge end of life
• Paper Jam
Instructions for clearing faults will be displayed on the controller.
Simply follow the instructions.
NOTE: For detailed information on clearing the printer faults,
refer to the DocuSP On-line Help.
When a paper jam occurs, the controller automatically displays a
fault window that lists individual faults. If you choose to display
additional information about a given fault, the system will then
display instructions or graphics that show the required actions.
After the jam is cleared, follow any additional displayed
instructions.
If the jam occurred in the middle of your job, the printer will
automatically recover and reprint the sheets that were jammed.
NOTE: When removing jammed sheets from the printer, use
the green handles and knobs.
The jam clearance areas are shown in Figure 4-8.
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
Operator Guide