Chapter 4 Connections; Cc-Link Side Terminal Block - Mitsubishi Electric AnyWire NZ2AW1C2AL User Manual

Cc-link-anywireaslink bridge module

Table of Contents

CONNECTIONS

4.1

The bridge module is handled as a remote device station of CC-Link. The CC-Link side terminal block is the connection

terminal which is easy to mount or remove.

Manufacturer: PHOENIX CONTACT GmbH & Co. KG (Contact: www.phoenixcotact.com)

Model: MSTB2,5/5-STF-5,08AU

Tightening torque: 0.2 to 0.3Nm

To tighten the terminal block, a flathead screwdriver having a tipped size of 0.63.5mm is required.

Before removing the CC-Link side terminal block, check that the fixing screws on both sides are completely loosened

(removed from the socket).

Pulling with excessive force while the fixing screws on both ends are still tightened may damage the devices.

Before tightening the terminal block, check that there are no short-circuits due to the disconnected or frayed wires and tighten

the screws at both ends securely. (Tightening torque: 0.2 to 0.3Nm)

The fixing screws are not tightened when shipped. Securely tighten the screws on both ends when tightening

the terminal block.

4 CONNECTIONS

4.1 CC-Link Side Terminal Block

Table of Contents

Troubleshooting